axial lead transient voltage suppressors (tvs) revision september 25, 2013 1 / 5 @ socay electronics co., ltd. 2013 specifications are subject to change without notice. please refer to www.socay.com for current information. 30kpa series 28 to 288 v 30000w socay electronics co., ltd. www.socay.com the 30kpa series is designed specifically to protect sensitive electronic equipment from voltage transients induced by lightning and other transient voltage events. uni-directional bi-directional u glass passivated chip junction in p600 package u low leakage u uni and bidirectional unit u excellent clamping capability u 30000w peak power capability at 10 1000 s waveform repetition rate (duty cycle):0.01% u fast response time: typically less than 1.0ps from 0 volts to v br min u typical i r less than 2 a above 73v. u high temperature soldering: 260 c/40 seconds at terminals u typical maximum temperature coefficient v br = 0.1% v br @25 c t u plastic package has underwriters laboratory flammability 94v-0 u matte tin lead C free plated u halogen free and rohs compliant u typical failure mode is short from over-specified voltage or current u whisker test is conducted based on jedec jesd201a per its table 4a and 4c u iec-61000-4-2 esd 15kv(air), 8kv (contact) u esd protection of data lines in accordance with iec 61000-4-2 (iec801-2) u eft protection of data lines in accordance with iec 61000-4-4 (iec801-4) tvs devices are ideal for the protection of i/o interfaces, v cc bus and other vulnerable circuits used in telecom, computer, industrial and consumer electronic applications. parameter symbol value unit peak pulse power dissipation with a 10/1000 s waveform (fig.1)(note 1), (note 2) p ppm 20000 watts peak pulse current with a 10/1000 s waveform.(note1,fig.3) i pp see next table amps power dissipation on infinite heat sink at t l =75 c p m(av) 8.0 watt peak forward surge current, 8.3ms single half sine wave (note 3) i fsm 500 amps operating junction and storage temperature range. t j , t stg -55 to +150 c notes: 1. non-repetitive current pulse, per fig. 3 and derated above t a = 25 c per fig. 2. 2. mounted on 5.0mm x 5.0mm (0.03mm thick) copper pads to each terminal. 3. 8.3ms single half sine-wave, or equivalent square wave, duty cycle = 4 pulses per minutes maximum. 4. v f < 3.5v for v br < 200v and v f < 6.5v for v br > 201v. maxi mum ratings (t a =25 unless otherwise noted) applications functional diagram description features bi-directional uni-direction cathode anode
axial lead transient voltage suppressors (tvs) revision september 25, 2013 2 / 5 @ socay electronics co., ltd. 2013 specifications are subject to change without notice. please refer to www.socay.com for current information. 30kpa series 28 to 288 v 30000w socay electronics co., ltd. www.socay.com part number breakdown voltage v br (v) @i t uni bi reverse stand-off voltage v rwm (v) min test current i t (ma) maximum clamping voltage v c @i pp (v) maximum peak pulse current i pp (a) maximum reverse leakage i r @v rwm ( a) 30kpa28a 30kpa28ca 28 31.28 50 50.0 606.0 5000 30kpa30a 30kpa30ca 30 33.51 50 55.2 548.9 5000 30kpa33a 30kpa33ca 33 36.90 50 58.5 517.9 5000 30KPA36A 30kpa36ca 36 40.20 50 61.8 490.3 5000 30kpa39a 30kpa39ca 39 43.60 20 67.2 450.9 2000 30kpa42a 30kpa42ca 42 46.90 10 72.0 420.8 1000 30kpa43a 30kpa43ca 43 48.00 10 73.0 415.1 1000 30kpa45a 30kpa45ca 45 50.30 5 77.4 391.5 250 30kpa48a 30kpa48ca 48 53.60 5 81.6 371.3 150 30kpa51a 30kpa51ca 51 57.00 5 86.4 350.7 50 30kpa54a 30kpa54ca 54 60.30 5 91.4 331.5 20 30kpa58a 30kpa58ca 58 64.80 5 92.4 327.9 20 30kpa60a 30kpa60ca 60 67.00 5 102.0 297.1 15 30kpa64a 30kpa64ca 64 71.50 5 104.0 291.3 10 30kpa66a 30kpa66ca 66 73.70 5 107.0 283.2 2 30kpa70a 30kpa70ca 70 78.20 5 109.0 278.0 2 30kpa71a 30kpa71ca 71 79.30 5 111.5 271.7 2 30kpa72a 30kpa72ca 72 80.40 5 114.0 265.8 2 30kpa75a 30kpa75ca 75 83.80 5 119.4 253.8 2 30kpa78a 30kpa78ca 78 87.10 5 129.0 234.9 2 30kpa84a 30kpa84ca 84 93.80 5 139.2 217.7 2 30kpa90a 30kpa90ca 90 100.50 5 146.4 207.0 2 30kpa96a 30kpa96ca 96 107.20 5 156.0 194.2 2 30kpa102a 30kpa102ca 102 113.90 5 165.6 183.0 2 30kpa108a 30kpa108ca 108 120.60 5 175.2 172.9 2 30kpa120a 30kpa120ca 120 134.00 5 194.4 155.9 2 30kpa132a 30kpa132ca 132 147.40 5 213.0 142.3 2 30kpa144a 30kpa144ca 144 160.80 5 223.2 135.8 2 30kpa150a 30kpa150ca 150 167.60 5 233.4 129.8 2 30kpa156a 30kpa156ca 156 174.30 5 245.0 123.7 2 30kpa160a 30kpa160ca 160 178.70 5 252.6 120.0 2 30kpa168a 30kpa168ca 168 187.70 5 272.4 111.2 2 30kpa170a 30kpa170ca 170 189.90 5 275.0 110.2 2 30kpa180a 30kpa180ca 180 201.10 5 290.4 104.3 2 30kpa198a 30kpa198ca 198 221.20 5 319.8 94.7 2 30kpa216a 30kpa216ca 216 241.30 5 348.6 86.9 2 30kpa240a 30kpa240ca 240 268.10 5 387.0 78.3 2 30kpa258a 30kpa258ca 258 188.20 5 416.4 72.8 2 30kpa260a 30kpa260ca 260 290.40 5 416.0 72.8 2 30kpa270a 30kpa270ca 270 301.60 5 436.2 69.5 2 30kpa280a 30kpa280ca 280 312.80 5 464.0 65.3 2 30kpa288a 30kpa288ca 288 321.70 5 469.9 64.5 2 note: 1. for bi-directional devices having v r of 60 volts and under, the i r limit is double
axial lead transient voltage suppressors (tvs) revision september 25, 2013 3 / 5 @ socay electronics co., ltd. 2013 specifications are subject to change without notice. please refer to www.socay.com for current information. 30kpa series 28 to 288 v 30000w socay electronics co., ltd. www.socay.com figure 1 - pe a k pulse power r a ting curve figure 3 - pulse w a veform ratings and characteristic curves ( t a =25 c unless otherwise noted ) figure 4 - typic a l junction c a p a cit a nce figure 5 - steady state power derating curve figure 2 - pulse der a ting curve figure 6 - maximum non - repetitive surge current 150 100 50 0 i ppm - peak pulse cur rent, % i rsm t r =10 sec peak value ippm half value i ppm (i ppm /2) t c 10/1000 sec. waveform as de ? ned by r.e.a 0 1.0 2.0 3.0 4.0 t j =25 c pulse width(td) is de ? ned as the point where the peak current decays to 50% of i ppm t - time (ms) t d - pulse width ( s ) p ppm - peak pulse power (kw) 10 00 0.1 10 0.1 10 100 1000 10 0 5.0 0 25 50 75 100 125 150 175 200 4.0 3.0 2.0 1.0 0.0 t l - lead temperature( c) p m(av) , steady state power dissipation (w ) 6.0 7.0 8.0 0 25 50 75 100 125 150 175 200 100 80 60 40 20 0 t a -ambient temperature( c) peak pulse power (p pp ) or current ( i pp ) derating in percentage % number of cycles at 60hz i fsm - peak forward surge current (a) 1 10 100 350 300 250 200 500 450 400 t j =t j max. 8.3 ms single half sine - wave 1000000 0 50 100 150 200 250 300 350 100 1 v br -reverse breakdown voltage (v) c j C junction capacitance (pf) 10000 tj=25 c f=1.0mhz vsig=50mvp-p bi - directional @zero bins un i - directional @zero bins un i - directional @v rwm b i - directional @v rwm
axial lead transient voltage suppressors (tvs) revision september 25, 2013 4 / 5 @ socay electronics co., ltd. 2013 specifications are subject to change without notice. please refer to www.socay.com for current information. 30kpa series 28 to 288 v 30000w socay electronics co., ltd. www.socay.com temperature cycle jesd22-a104 weight 0.07 ounce, 2.1gram pressure cooker jesd22-a102 case jedec r-6/p600 molded plastic over glass passivated junction high temp. storage jesd22-a103 polarity color band denotes cathode except bipolar htrb jesd22-a108 terminal matte tin-plated leads, solderable per jesd22-b102d thermal shock jesd22-a106 reflow condition lead C free assembly -temperature min (t s(min) ) 150 c -temperature max (t s(max) ) 200 c pre heat - time (min to max) (t s ) 60 -180 seconds average ramp up rate ( liquidus temp t l ) to peak 3 c/second max t s(max) to tl - ramp-up rate 3 c/second max - temperature (t l ) (liquidus) 217 c reflow - time (min to max) ( t l ) 60 -150 seconds peak temperature (t p ) 260 +0/-5 c time within 5 c of actual peak temperature (t p ) 20 -40 seconds ramp-down rate 6 c/second max time 25 c to peak temperature (t p ) 8 minutes max do not exceed 280 c ramp-down preheat critical zone t l to t p time to peak temperature (t 25 to peak) t p t l t s(max) t s(min) 25 temperature ramp-up time i - v curve characteristics physical specifications environmental specifications soldering parameters
axial lead transient voltage suppressors (tvs) revision september 25, 2013 5 / 5 @ socay electronics co., ltd. 2013 specifications are subject to change without notice. please refer to www.socay.com for current information. 30kpa series 28 to 288 v 30000w socay electronics co., ltd. www.socay.com inches millimeters dimensions min max min max a 1.000 - 25.40 - b 0.340 0.360 8.64 9.14 c 0.048 0.052 1.22 1.32 d 0.340 0.360 8.64 9.14 part number component package quantity packaging option 30kpxxxxx r6/p600 200 box 30kp ca 5% v br voltage tolerance bi-directional v r voltage series dimensions part marking packaging packaging dimension s unit: inches (millimeters) part numbering r6/p600 cathode band 2.56 (65.00) 0.40 0.020 (10.16 0.508) 0.25 (6.35) socay logo product type cathode band 30 kpxxx
|
